MAX30102 Heart Rate and Pulse Oximeter Sensor Module (Black)
EGP 109.90
See other suppliers →Description
MAX30102 Heart Rate and Pulse Oximeter Sensor Features: Optical Heart-Rate Monitor and Pulse Oximetry Solution Upgraded version of MAX30100, the MAX30102 has better accuracy and reliability and some new features. New features include : Proximity sensing, and better ambient light cancellation. Tiny breakout board Low power Highly-integrated, small-size sensor Non-chest based heart-rate/SpO2 detection Ultra-low power consumption Specifications: Power supply: 3.3V to 5.5V Current draw: ~600μA (during measurements), Current draw: ~0.7μA (during standby mode) Red LED Wavelength: 660nm IR LED Wavelength: 880nm Temperature Range: -40˚C to +85˚C Temperature Accuracy: ±1˚C Pin Configuration: VIN is the power pin. You can connect it to 3.3V or 5V output from your Arduino. SCL is the I2C clock pin, connect to your Arduino’s I2C clock line. SDA is the I2C data pin, connect to your Arduino’s I2C data line. INT The MAX30102 can be programmed to generate an interrupt for each pulse. This line is open-drain, so it is pulled HIGH by the onboard resistor. When an interrupt occurs the INT pin goes LOW and stays LOW until the interrupt is cleared. IRD The MAX30102 integrates an LED driver to drive LED pulses for SpO2 and HR measurements. Use this if you want to drive the IR LED yourself, otherwise leave it unconnected. RD pin is similar to the IRD pin, but is used to drive the Red LED. If you don’t want to drive the red LED yourself, leave it unconnected. GND is the ground. Applications: Fitness Assistant Devices Medical Monitoring Devices Home Heart Rate and SpO2 Monitoring
From the supplier's page.
makhzan doesn't sell — every offer opens the supplier's own site.