Carbon Resistor 75Ω 0.5W Through Hole

Description

Carbon Resistor 75Ω 0.5W Through Hole The Carbon Resistor 75 Ω 0.5 W through-hole is a carbon-film fixed resistor in the CR series designed for general-purpose electronic use. In the CR family it corresponds to the 1/2 W power class and follows the standard cylindrical, axial-lead through-hole form factor. The component is constructed on a ceramic core with a deposited carbon film that establishes its 75-ohm resistance value, then coated with epoxy for insulation and mechanical protection. As a 0.5 W carbon-film resistor it delivers stable resistance at room temperature and is intended for low-to-moderate power dissipation applications. Temperature coefficient and tolerance follow the CR series specifications (tolerances ±5% standard, ±2% option), and the part is tested for load-life, humidity and pulse overload performance according to the CR series test methods (JIS C 5202). It shows predictable drift characteristics within the specified limits after stress tests. Because of its compact size (bulk dimensions for the 1/2 W CR type) and robust epoxy coating, this 75 Ω 0.5 W resistor is useful where a reliable, low-cost passive resistor is required. It is solderable per the supplier’s solderability and solder-heat recommendations and offers long service life (use life ≥10,000 hours under rated conditions). Features: Carbon-film fixed resistor, through-hole (CR series). Rated power class: 0.5 W (1/2 W). Standard tolerance: ±5% (±2% available). Ceramic core with high-stability carbon film. Epoxy resin coating for insulation and solvent resistance. Tinned copper leads (suitable for reliable soldering). Withstands standard load-life, humidity and pulse overload tests (per JIS C 5202). Specifications: Specification: Details: Product family: CR series – Carbon film fixed resistor Resistance: 75 Ω (nominal) Rated power: 0.5 W (1/2 W) Tolerance: ±5% standard (±2% option) Temperature coefficient: See CR series TCR table (10 Ω–1 MΩ: ±350 ppm ) Operating temperature range: −55 °C to +155 °C Bulk dimensions (typical for 1/2W): L ≈ 9.0 mm Ø ≈ 3.5 mm lead Ø ≈ 0.50 mm Insulation / withstanding voltage: Insulation resistance >1000 MΩ see withstanding voltage table per power class Life / reliability: Use life ≥10,000 h under rated conditions failure rate ≤10 PPM Solderability / solder heat: Solderability ≥95% coverage solder heat per table (230 °C dwell tests) Pinout Diagram: Footprint Diagram: Applications: General-purpose electronic circuits. Signal conditioning and bias networks. Current limiting in small-signal circuits. Pull-up / pull-down resistor in logic circuits. Repair, prototyping and educational kits. Package Contents: 1x Carbon Resistor 75Ω 0.5W Through Hole Datasheet

From the supplier's page.