Relay Module 6 Channel 5V
EGP 165
See other suppliers →Description
The module has six relays with a coil powered with a voltage of 5 V along with optoelectronic insulation. The system allows you to control actuators with microcontroller ports or any development kit. Specifications: Supply voltage VCC: 5 V Activated with the low-status Relay Coil voltage: 5 V The maximum voltage of contacts: 250 VAC, 125 VDC* Maximum current: 10 A Optoelectronic insulation 6 LEDs signaling the activation of relays The dimensions of the board are 106 x 57 x 17mm Weight: 82 g Diameter of mounting holes: 3 mm Description The module allows control of the actuators consuming the current up to 10 A using the microcontroller’s ports or any development kit (including Arduino, Raspberry Pi, and STM32Discovery). Optical insulation separates the control signal from the part associated with the power of the relay, thereby providing work safety for the management system. The product is compatible with Arduino For relay control, sufficient is a digital control signal from the pins of the Arduino . Connection For proper operation, it is sufficient to connect the power of the relay coil and the digital control signal. Leads are the standard gold in strips with a pitch of 2.54 mm, which enables connection using the popular connecting cables. The relay has the following pins VCC, DC+ – power supply of the optocoupler GND , DC- – ground of the system IN1 … IN6 – control inputs of the relay are activated by the low-status Relay Contacts NC = Normally Closed side of the relay Center Terminal = Common terminal usually connects to the load power source NO = Normally Open side of the relay 1×3 Header JD-VCC = Opto-isolator power input. Jumper to Vcc to run off same power supply as the logic (default mode). If opto-isolation is desired, remove jumper and apply a separate 5V supply to this pin. VCC = Same as Vcc on the 1×10 header GND = Same as GND on the 1×10 header. Can be used to connect ground of separate 5V power supply (if used) Examples of application Driver of lighting The driver of the actuators Switch for electric devices, including motors
From the supplier's page.
makhzan doesn't sell — every offer opens the supplier's own site.