Weight Sensor (Load Cell) 0-1000g 1kg
EGP 160
See other suppliers →Description
This weight sensor (load cell) is suitable for electronic balance and other high accuracy electronic weighing devices. Specifications Rated load: 1000g Output : ± 0.05mv / v Temperature zero drift : 0.1% F.S Output sensitivity : 1.0 ± 0.1 mv / v Temperature sensitivity : 0.05% F.S Repeatability: 0.03% F.S Insulation resistance : ≥ 2000MΩ Excitation voltage : 5-10VDC Dimensions : 75x12.7x12.7mm Wire Connection The load cell acts like a bridge, it has 4 colored wires as follows VCC : Red wire GND : Black wire Signal + : Green wire Signal - : White wire Installation in Weight Scale It is recommended to use the load cell with Future Electronics Egypt weight scale analog to digital and amplifier module as shown in photo below. In this case you can connect the weight scale module to your Arduino or Micro-controller through serial pins and record or display your measurements For basics of load cell and weight sensors, please click here
From the supplier's page.
makhzan doesn't sell — every offer opens the supplier's own site.