L298 Dual Motor Driver Module 2A

This driver module is based on L298N H-bridge, a high current, high voltage dual full bridge driver manufactured by ST company. It can drive up to 2 DC motors 2A each. It can also drive one stepper motor or 2 solenoids. The driver can control both motor RPM and direction of rotation. The RPM is controlled using PWM input to ENA or ENB pins, while of rotation direction is controlled by suppling high and low signal to EN1-EN2 for the first motor or EN3-EN4 for second motor. This Dual H-Bridge driver is capable of driving voltages up to 46V. Features • Dual H bridge drive (can drive 2 DC motors) • Chip L298N • Logical voltage 5V • Drive voltage 5V-35V • Logic current 0mA-36mA • Drive current 2A(For each DC motor)) • Weight 30g • Size: 43*43*27mm L298 Driver module pin connection and arduino tutorial

Description The module with the popular L298N driver allows you to control the direction and speed of two DC motors. Thanks to the screw connectors, ARK power and engines can be easily connected by fastening the wires using a screwdriver. The control signals were output into popular gold pin connectors that allow you to combine the system with commissioning plates, for example, with Arduino using wires. Leads Pins Details Out 1: Motor A lead out Out 2: Motor A lead out Out 3: Motor B lead out Out 4: Motor B lead out GND: Ground 9-35V: 9-35V input ( unnecessary if your power source is 9v-35v, if the power source is 9 v-35v then it can act as a 5v out ) EnA: Enables PWM signal for Motor A In1: Enable Motor A In2: Enable Motor A In3: Enable Motor B In4: Enable Motor B EnB: Enables PWM signal for Motor B The truth table of driver L298 IN1 / IN3 IN2 / IN4 THE OUTPUTS OF THE ENGINES high state low state The motor rotates with the maximum given speed using PWM (different from 0) in a clockwise direction. low state high state The motor rotates at the maximum given speed using PWM (not equal to 0) in a counterclockwise direction. low state low state When indicated high state at the PWM input – fast braking of the motors (fast stop). high state high state When indicated high state at the PWM input – fast braking of the motors (fast stop). Specifications Operating voltage: 5-35V Supply voltage of the logic part: 5 V Built-in voltage regulator 5 V to power the logic part Maximum output current: 2 A per channel Module to control two DC motors or one stepper motor The outputs for the motors and the power inputs were displayed on the screw connectors ARK The input pins of the logic part are available on the gold pin connectors – 2.54 mm pitch The board consists of all necessary for the proper operation of the controller, passive components The system has a mounted radiator Tile sizes: 45.5 x 45.5 x 30 mm