Ethernet Shield Module W5100 For Arduino

Part number W5100

3 offers in stock at 3 shopsEGP 415 – 517.99

EGP 415 at Makers Electronics

Offers

lowest price first

Each offer shows the shop's own title.

Ethernet Shield Module W5100 For Arduino
Makers Electronics
checked 20 days ago
EGP 415
View
W5100 Ethernet Shield For Arduino Uno
Ampere Electronics
checked 15 days ago
EGP 475
View
Arduino Shield – Ethernet Shield W5100 + SD Card
Most Electronic
checked 12 days ago
EGP 517.99
View

Show 1 out of stock offer

Arduino Shield - Ethernet Shield W5100 + SD Card
RAM ElectronicsOut of stock
checked 11 days ago
EGP 425
View

Details

FromAmpere ElectronicsMakers ElectronicsMost Electronic

From Ampere Electronics's description

W5100 Ethernet Shield For Arduino Uno The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top. The latest revision of the shield adds a micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Duemilanove and Mega (using the Ethernet library coming in Arduino 0019). An SD card library is not yet included in the standard Arduino distribution, but the sdfatlib by Bill Greiman works well. The latest revision of the shield also includes a reset controller, to ensure that the W5100 Ethernet module is properly reset on power-up. Previous revisions of the shield were not compatible with the Mega and need to be manually reset after power-up. The original revision of the shield contained a full-size SD card slot; this is not supported. Arduino communicates with both the W5100 and SD card using the SPI bus (through the ICSP header). This is on digital pins 11, 12, and 13 on the Duemilanove and pins 50, 51, and 52 on the Mega. On both boards, pin 10 is used to select the W5100 and pin 4 for the SD card. These pins cannot be used for general i/o. On the Mega, the hardware SS pin, 53, is not used to select either the W5100 or the SD card, but it must be kept as an output or the SPI interface won’t work. Note that because the W5100 and SD card share the SPI bus, only one can be active at a time. If you are using both peripherals in your program, this should be taken care of by the corresponding libraries. If you’re not using one of the peripherals in your program, however, you’ll need to explicitly deselect it. To do this with the SD card, set pin 4 as an output and write a high to it. For the W5100, set digital pin 10 as a high output. The shield provides a standard RJ45 ethernet jack. Specification: Controller: w5100 Size: 7.4 x 5.4 x 2.4 (2.91 x 2.12 x 0.94inch) MAC address: 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED byte mac[] = { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED } Package Includes : 1 x W5100 Ethernet Shield For Arduino Uno Relate Products: Arduino | Shields

Ethernet Shield Module W5100 For Arduino

Offers

Details

From Ampere Electronics's description

From Makers Electronics's description

From Most Electronic's description

Similar products